Datamax E-Class Mark II Programmer's Manual

Class Series 2 Programmer’s Manual 183
Appendix D
Reset Codes
The most common transmitted error codes are:
Uppercase “R”
This code is sent every time the printer is turned “On,” signaling a hardware reset.
Uppercase “T”
This code signals a software reset. A software reset is made by sending the command
sequence to the printer or by performing a reset using the front panel keys.
Lowercase “v”
There is an input buffer overflow situation, caused when an overflow of data is sent to
the printer.

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz