Datamax E-Class Mark II Programmer's Manual

Extended System-Level Command Functions
116 Class Series 2 Programmer’s Manual
STX KtE Write Electronic Article Surveillance (EAS) Bit
(Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface)
This command writes the EAS bit for Philips ISO tags.
Syntax:
<STX>KtEabcc
a
- The number of retry attempts, 0-9.
b
- Electronic Article Surveillance (EAS) option:
0 = Set EAS
1 = Reset EAS
2 = Test EAS
Where:
cc
- Two character Manufacturer’s Code, representing one
byte.
Sample:
<STX>KtE9004[CR]
The sample above writes the EAS bit for Philips (0x04), retrying
nine times if necessary.
STX KtH Read and Feedback Tag Information to Host
(Direct Mode – HF [13.56 MHz] ISO15693 Tag Interface)
This command returns the tag info to host.

This command only works when the Data Flag for the tag is 0x0F (i.e., when the tag
contains DSFID, AFI, VICC and IC data).
Syntax:
<STX>KtH
Sample Feedback:
DATA FLAG: 0x0F
TAG ID: E004010000751412
DSFID: 0xE3
AFI: 0x01
NUM BLK: 0x1B
BLK SIZ: 0x03
IC REF: 0x01

Datamax E-Class Mark II Specifications

General

Resolution	203 dpi (8 dots/mm) or 300 dpi (12 dots/mm)
Operating Temperature	40°F to 95°F (4°C to 35°C)
Storage Temperature	-40°F to 140°F (-40°C to 60°C)
Print Method	Direct Thermal / Thermal Transfer
Max Print Speed	6 inches per second (ips)
Memory	8 MB DRAM
Interface	Serial, Parallel, USB
Media Type	Labels, Tags, Receipts
Media Width	0.75" (19 mm) to 4.65" (118 mm)
Media Thickness	0.0025 to 0.008 inches (0.0635 to 0.2032 mm)
Power Requirements	100-240 VAC, 50-60 Hz