Dell 0G8DW - Page 53

Option Description
Dell Controlled
Turbo
Controls the turbo engagement. Enable this option only when System Prole is set to Disabled.
NOTE: Depending on the number of installed processors, there might be up to two processor listings.
Dell AVX Scaling
Technology
Enables you to congure the Dell AVX scaling technology. This option is set to 0 by default.
Number of Cores
per Processor
Controls the number of enabled cores in each processor. This option is set to All by default.
Processor Core
Speed
Species the maximum core frequency of the processor.
Process Bus Speed Displays the bus speed of the processor.
Processor n
NOTE: Depending on the number of processors, there might be up to two processors listed.
The following settings are displayed for each processor installed in the system:
Option Description
Family-Model-
Stepping
Species the family, model, and stepping of the processor as dened by Intel.
Brand Species the brand name.
Level 2 Cache Species the total L2 cache.
Level 3 Cache Species the total L3 cache.
Number of Cores Species the number of cores per processor.
Maximum Memory
Capacity
Species the maximum memory capacity per processor.
Microcode Species the microcode.
SATA Settings
You can use the SATA Settings screen to view the settings of SATA devices and enable SATA and PCIe NVMe RAID mode on your system.
Viewing SATA Settings
To view the SATA Settings screen, perform the following steps:
1 Power on, or restart your system.
2 Press F2 immediately after you see the following message:
F2 = System Setup
NOTE
: If your operating system begins to load before you press F2, wait for the system to nish booting, and then
restart your system and try again.
3 On the System Setup Main Menu screen, click System BIOS.
4 On the System BIOS screen, click SATA Settings.
Pre-operating system management applications
53