Figure 57. Set the anti-tilt wires to the locked position and tightening the screws
Next steps
1. Replace the processor air shroud.
2. Follow the procedure listed in After working inside your system.
Expansion cards and expansion card risers
NOTE:
A system event entry is logged in the iDRAC Lifecycle Controller if an expansion card riser is not supported or
missing. It does not prevent your system from turning on. However, if a F1/F2 pause occurs with an error message,
see Troubleshooting expansion cards section in the Dell EMC PowerEdge Servers Troubleshooting Guide at www.dell.com/
poweredgemanuals.
Installing and removing system components 67
To Next Page
Loading...
