632 | IPv4 Routing
www.dell.com | support.dell.com
• ip name-server
• ip proxy-arp
• ip redirects
• ip route
• ip source-route
• ip unreachables
• ip vlan-flooding
• load-balance (C-Series and S-Series)
• load-balance (E-Series)
• management route
• show arp
• show arp retries
• show hosts
• show ip cam linecard
• show ip cam stack-unit
• show ip fib linecard
• show ip fib stack-unit
• show ip flow
• show ip interface
• show ip management-route
• show ipv6 management-route
• show ip protocols
• show ip route
• show ip route list
• show ip route summary
• show ip traffic
• show protocol-termination-table
• show tcp statistics
arp
ces
Use Address Resolution Protocol (ARP) to associate an IP address with a MAC address in the switch.
Syntax
arp vrf {vrf name} ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
vrf name
E-Series Only: Enter the VRF process identifier to tie the static route to the VRF
process.
ip-address
Enter an IP address in dotted decimal format.
To Next Page