Installing the USB Type-C module
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the USB Type-C module and provides a visual representation of the installation
procedure.
Figure 85. Installing the USB Type-C module
Steps
1. Align and place the USB Type-C module over the USB Type-C ports on the system board.
2. Replace the three screws (M2x5) to secure the USB Type-C module to the system board.
Next steps
1. Install the system board.
2. Install the battery frame.
3. Install the heat sink.
4. Install the left/video fan.
5. Install the right/processor fan.
6. Install the WWAN module, if available.
7. Install the wireless card.
8. Install the M.2 2230 solid-state drive or M.2 2280 solid-state drive, whichever is applicable.
9. Install the memory module.
10. Install the battery.
11. Install the base cover.
12. Follow the procedure in After working inside your computer.
118
Removing and installing Field Replaceable Units (FRUs)
To Next Page
Loading...
