Figure 23. Removing the M.2 2280 solid state drive
Steps
1. Remove the screw (M2x4) that secures the M.2 2280 solid state drive to the system board.
2. Remove the M.2 2280 solid state drive from the M.2 card slot (SSD1 or SSD2, whichever is applicable) on the system board.
NOTE:
For computers shipped with a WWAN module installed, the M.2 2280 solid state drive can only be installed in
SSD2 slot (primary slot).
Installing the M.2 2280 solid state drive
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the M.2 2280 solid state drive (SSD) and provides a visual representation of the
installation procedure.
56
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
