Installing the display hinges
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the display hinges and provide a visual representation of the installation procedure.
Figure 71. Installing the display hinges
Steps
1. Align and place the right display hinge on the display back-cover and antenna assembly.
2. Replace the three screws (M2.5x3.5) to secure the right display hinge to the display back cover.
3. Repeat steps 1 and 2 to secure the left display hinge to the display back cover.
4. Adhere the tapes to secure the wireless-antenna cables and WWAN-antenna cables, if available, to the display back-cover
and antenna assembly.
5. Adhere the display cable and secure it to the display back-cover and antenna assembly.
Removing and installing Field Replaceable Units (FRUs)
103
To Next Page
Loading...
