Removing and installing Customer
Replaceable Units (CRUs)
The replaceable components in this chapter are Customer Replaceable Units (CRUs).
CAUTION: Customers can replace only the Customer Replaceable Units (CRUs) following the safety precautions
and replacement procedures.
NOTE: The images in this document may differ from your computer depending on the configuration you ordered.
Base cover
Removing the base cover
Prerequisites
1. Follow the procedure in Before working inside your computer.
CAUTION:
Ensure that your computer is in Service Mode. If the computer does not turn on, does not enter
Service Mode, or does not support Service Mode, proceed to disconnect the battery cable.
About this task
The following images indicate the location of the base cover and provide a visual representation of the removal procedure.
5
44 Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
