Figure 33. Installing the speakers
2. Route the speaker cable through the routing guides on the palm-rest assembly.
3. Replace the four screws (M1.6x3) to secure the speakers to the palm-rest assembly.
4. Connect the speaker cable to the connector (SPK1) on the system board.
Next steps
1. Install the base cover.
2. Follow the procedure in After working inside your computer.
Right/Processor fan
Removing the right/processor fan
Prerequisites
1. Follow the procedure in Before working inside your computer.
2. Remove the base cover.
3. Remove the wireless card.
4. Remove the WWAN module, if available.
About this task
The following images indicate the location of the right/processor fan and provide a visual representation of the removal
procedure.
66
Removing and installing Customer Replaceable Units (CRUs)
To Next Page
Loading...
