Dell Pro Max 16 - Installing the Palm-Rest Assembly

Figure 92. Palm-rest assembly
Steps
After performing the Prerequisites, you are left with the palm-rest assembly.
Installing the palm-rest assembly
CAUTION: The information in this installation section is intended for authorized service technicians only.
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
NOTE:
The system board can be installed with the heat sink attached to it in order to simplify the procedure and preserve
the thermal bond between the system board and heat sink.
The image below shows the palm-rest assembly.
Removing and installing Field Replaceable Units (FRUs)
127