Dell Pro Max 16 - Display Hinges; Removing the Display Hinges

Figure 69. Installing the display panel
Steps
1. Place the display panel and display assembly on a clean and flat surface.
2. Connect the display cable to the connector on the display panel.
3. Adhere the tape to secure the display cable to the connector on the display panel.
4. Gently turn the display panel over and place the display panel in the slot on the display back cover.
5. Replace the four screws (M2x3) to secure the display-panel brackets to the display back-cover and antenna assembly.
Next steps
1. Install the display bezel.
2. Install the display assembly.
3. Install the WWAN module, if available.
4. Install the wireless card.
5. Install the base cover.
6. Follow the procedure in After working inside your computer.
Display hinges
Removing the display hinges
CAUTION: The information in this removal section is intended for authorized service technicians only.
Prerequisites
1. Follow the procedure in Before working inside your computer.
Removing and installing Field Replaceable Units (FRUs)
101