Table 44. System Setup options—Power menu(continued)
Power
Peak Shift
Enable Peak Shift Enables or disables the computer to run on battery during peak power usage
hours.
By default, the Enable Peak Shift option is disabled.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
Type-C Connector Power Allows you to set the maximum power that can be drawn from the Type-C
connector.
By default, the Type-C Connector Power option is set to 7.5 W.
USB PowerShare
Enable USB PowerShare Enables or disables the USB PowerShare on the computer.
By default, the Enable USB PowerShare option is disabled.
Thermal Management This setting allows for cooling of fan and processor heat management to adjust
system performance, noise and temperature.
By default, the Optimized option is selected.
USB Wake Support
Wake on Dell USB-C Dock When enabled, connecting a Dell USB-C Dock wakes the computer from Standby,
Hibernate, and Power Off.
By default, the Wake on Dell USB-C Dock option is enabled.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
Block Sleep Enables or disables the computer from entering Sleep (S3) mode in the operating
system.
By default, the Block Sleep option is disabled.
NOTE: When enabled, the computer does not go to Sleep, Intel Rapid Start
is disabled automatically, and the operating system power option is blank if it
was set to Sleep.
NOTE: To view this option, enable Advanced Setup mode as described in
View Advanced Setup options.
Lid Switch
Enable Lid Switch Enables or disables the Lid Switch.
By default, the Enable Lid Switch option is enabled.
Power On Lid Open When enabled, allows the computer to turn on from the off state whenever the
lid is opened.
By default, the Power On Lid Open option is enabled.
Table 45. System Setup options—Security menu
Security
TPM 2.0 Security Trusted Platform Module (TPM) is a security device that stores computer-
generated keys for encryption and features such as BitLocker, Virtual Secure
Mode, remote Attestation.
By default, the TPM 2.0 Security option is enabled.
BIOS Setup 139
To Next Page
Loading...
