Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following images indicate the location of the battery frame and provide a visual representation of the installation procedure.
Figure 45. Installing the battery frame
Steps
1. Align and place the battery frame in the slot on the palm-rest assembly.
2. Replace the ten screws (M2x3) to secure the battery frame to the palm-rest assembly.
3.
NOTE: Steps 3 and 4 apply only to computers shipped with a WWAN module installed.
Align and place the WWAN-module shield on the solid state drive.
4. Replace the two screws (M2x3) to secure the WWAN-module shield to the system board.
Next steps
1. Install the wireless card.
2. Install the battery.
Removing and installing Field Replaceable Units (FRUs)
79
To Next Page
Loading...
