64
Chapter 4 Creating a Project
4.8 USB Tool
Instead of direct data transfer between a computer running WINCAPS III and the robot controller, a USB memory
is available as a media for data exchange between them.
4.8.1 Reading data from USB memory
Follow the FDTool wizard to read data from a USB memory.
Operating procedure
1. Select Tool|USB|Read to start the FDTool wizard.
Read data from drive
This field specifies a drive for reading a USB memory.
New Project
This radio button is for creating a new project and reading data from a USB memory into the project.
Enter a project name and select a location for saving the project.
Merge with Existing Project
This radio button is for selecting an existing project and reading data from a USB memory into the
project. The data read from a USB memory merges with data in the existing project.
To Next Page
Loading...