DEV 1951 - Page 3

User Manual DEV 1951
 Copyright DEV Systemtechnik GmbH 2004-2017 3
4 Installation Instructions ------------------------------------------------ 25
4.1 Scope of Delivery --------------------------------------------------------------------- 25
4.2 Installation of the Product --------------------------------------------------------- 25
4.2.1 Mechanical Integration of the Product ------------------------------------------ 25
4.2.2 Grounding, Data Cables, Alarm Cable, and Power Connection ------------ 25
4.2.3 Connection of Optical Cables ------------------------------------------------------ 26
4.2.4 Connection of RF Signal Cables ---------------------------------------------------- 26
4.2.5 Installation and Exchange of Modules ------------------------------------------- 27
4.2.6 Reset of the Device and the Restore of Factory Defaults ------------------- 27
4.2.7 Configuration Mode ------------------------------------------------------------------ 28
4.3 Device Factory Settings ------------------------------------------------------------- 29
4.3.1 Factory Settings for Sensing Switch Modules ---------------------------------- 29
4.3.2 Factory Communication Protocol Configuration ------------------------------ 29
4.3.3 Factory Network Settings ----------------------------------------------------------- 29
4.3.4 Factory SNMP Settings --------------------------------------------------------------- 30
4.3.5 Factory Sandar Prosan Protocol Settings ---------------------------------------- 30
4.3.6 Factory Leitch Protocol Settings --------------------------------------------------- 30
4.3.7 Factory QEC Protocol Settings ----------------------------------------------------- 30
4.4 Communication Interface Configuration --------------------------------------- 30
4.4.1 Serial Interface------------------------------------------------------------------------- 30
4.4.1.1 Standard Serial Interface Configuration --------------------------------------------------- 31
4.4.1.2 Sandar Prosan Protocol Serial Interface Configuration -------------------------------- 31
4.4.2 Ethernet Interface -------------------------------------------------------------------- 31
4.4.2.1 Ethernet Connection ---------------------------------------------------------------------------- 31
4.4.2.2 Network Setup via the Serial Interface ----------------------------------------------------- 32
4.4.2.2.1 Start and Termination of the Configuration Program ---------------------------------------------- 32
4.4.2.2.2 1 set IP address ----------------------------------------------------------------------------------------------- 34
4.4.2.2.3 2 set netmask ------------------------------------------------------------------------------------------------- 34
4.4.2.2.4 3 set gateway -------------------------------------------------------------------------------------------------- 34
4.5 Maintenance of the Product ------------------------------------------------------- 34
5 Operation of the Product ---------------------------------------------- 35
5.1 Modes of Operation ----------------------------------------------------------------- 35
5.1.1 Local Mode ----------------------------------------------------------------------------- 35
5.1.2 Remote Mode ------------------------------------------------------------------------- 35
5.1.3 Auto Mode ----------------------------------------------------------------------------- 36
5.1.3.1 Autonomous Switching Functionality ------------------------------------------------------ 36
5.1.4 Individual/Simultaneous Switching Mode -------------------------------------- 40
5.2 Initialization of the Device --------------------------------------------------------- 40
5.3 Operation via the Device Panel --------------------------------------------------- 40
5.4 Control via the Digital Interface -------------------------------------------------- 41
5.5 Operation via Web Interface ------------------------------------------------------ 43
5.5.1 Start of the Web Interface ---------------------------------------------------------- 43