Digi CM 8 - Page 113

Rackable Systems management card Setup the Digi CM Unit to support the Rackable Systems management card
Digi CM User Guide 113
Save Save currently displayed message to flash memory.
Show saved LCD
message upon
startup
The first columns shows the current status: Yes or No.
This parameter defines which message is displayed upon startup of the
server, either the saved message or the standard: “Rackable Systems
Phantom Vx.xx”.
Contrast Set a contrast for the LCD panel.
The default is 50, the range is 0 – 100.
Phantom
Properties
Temperature Indicates current temperature inside the Rackable Systems Server.
Power delay Time in seconds before the server starts up after applying power (0-98
seconds, 99 means no power on delay).
Power sense The power sense option toggles between sensing server power on the reset
header or on the J7 connector. Most applications will use the “Reset” option.
This option should be set before shipping from Rackable Systems, but may
need to be reset if somehow changed after shipping.
Communication
settings
Baud Rate
Configure the baud rate used to communicate with the Rackable Systems
Management Card. For this change to become effective reset or power-cycle
the Management card, and be sure to switch the port settings in the Digi CM
unit’s port settings.
Field Description