Interfaces Local Area Networks (LANs)
Digi Connect IT® 16/48 User Guide
148
1. Disable the DHCP server, if it is enabled:
(config network interface my_lan ipv4 dhcp_relay 1)> .. .. dhcp_server
enable false
(config network interface my_lan ipv4 dhcp_relay 1)>
6. Save the configuration and apply the change:
(config network interface lan1 ipv4 dhcp_relay 1)> save
Configuration saved.
>
7. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Show DHCP server status and settings
View DHCP status to monitor which devices have been given IP configuration by the Connect IT device
and to diagnose DHCP issues.
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access.
2. On the main menu, click Status
3. Under Networking, click DHCP Leases.
Command line
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. Enter the show dhcp-lease command at the Admn CLI prompt:
> show dhcp-lease
IP Address Hostname Expires
------------- --------------- -------
192.168.2.194 MTK-ENG-USER1
192.168.2.195 MTK-ENG-USER2
>
3. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Create a Virtual LAN (VLAN) route
Virtual LANs (VLANs) allow splitting a single physical LAN into separate Virtual LANs. This is useful for
security reasons, and also helps to reduce broadcast traffic on the LAN.
To Next Page
Loading...
Need help?
General