System administration Disable device encryption
Digi Connect IT® 16/48 User Guide
617
h. Sandbox is enabled by default. This option protects the script from accidentally destroying
the system it is running on.
(config system schedule script 0)> sandbox true
(config system schedule script 0)>
8. Allow for the configuration to be updated, including by custom scripts, during the maintenance
window:
system schedule maintenance config_check value
(config)>
where value is either true or false. yes or no, and 1 or 0 are also allowed.
9. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Disable device encryption
You can disable the cryptography on your Connect IT 16/48 device. This can be used to ship unused
devices from overseas without needing export licenses from the country from which the device is
being shipped.
When device encryption is disabled, the following occurs:
n The device is reset to the default configuration and rebooted.
n After the reboot:
l Access to the device via the WebUI and SSH are disabled.
l All internet connectivity is disabled, including WANand WWAN. Connectivity to central
management software is also disabled.
l All IP networks and addresses are disabled except for the default 192.168.210.1/24
network on the local LAN Ethernet port. DHCP server is also disabled.
The device can only be accessed by using telnet from a local machine connecting to the
192.168.210.1/24 network.
Disabling device encryption is not available in the WebUI. It can only be performed from the Admin CLI.
Command line
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
To Next Page
Loading...
Need help?
General