Digi Connect IT 16 User Manual

File system The Connect IT 16/48 local file system
Digi Connect IT® 16/48 User Guide
651
The Connect IT 16/48 local file system
The Connect IT 16/48 local file system has approximately 4.5 GB of space available for storing files,
such as alternative configuration files and firmware versions, and release files, such as cellular module
images. The writable directories within the filesystem are:
n /tmp
n /opt
n /etc/config
Files stored in the /tmp directory do not persist across reboots. Therefore, /tmp is a good location to
upload temporary files, such as files used for firmware updates. Files stored in /opt and /etc/config do
persist across reboots, but are deleted if a factory reset of the system is performed. See Erase device
configuration and reset to factory defaults for more information.
Display directory contents
To display directory contents by using the WebUI or the Admin CLI:
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access.
2. On the menu, click System. Under Administration, click File System.
The File System page appears.
3. Highlight a directory and click  to open the directory and view the files in the directory.
Command line
1. Log into the Connect IT 16/48 command line as a user with Admin access.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the Admin CLI prompt, type ls /path/dir_name. For example, to display the contents of the
/etc/config directory:

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English