Configuration and management Change the default password for the admin user
Digi Connect IT® 16/48 User Guide
31
Change the default password for the admin user
The unique, factory-assigned password for the default admin user account is printed on the bottom
label of the device and on the loose label included in the package. When you first log into the WebUI or
the command line, you will be required to change the password for the admin user prior to being able
to save any configuration changes.
If you erase the device configuration or reset the device to factory defaults, the password for the
admin user will revert to the original, factory-assigned default password.
Note If your device was manufactured prior to the release of firmware version 19.11.x, the default
user name may be root.
WebUI
1. Log into the Connect IT 16/48 WebUI as a user with full Admin access rights.
2. On the menu, click System. Under Configuration, click Device Configuration.
The Configuration window is displayed.
3. Click Authentication > Users > admin.
4. Enter a new password for the admin user. The password must be at least ten characters long
and must contain at least one uppercase letter, one lowercase letter, one number, and one
special character.
5. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
To Next Page
Loading...
Need help?
General