Digi Connect IT 16 User Manual

Services Location information
Digi Connect IT® 16/48 User Guide
371
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Enable or disable the USB module:
a. Use the show command to determine the index number of the USB location source:
(config)> show service location source
0
enable true
no label
type usb
1
enable true
no label
type gnss
(config)>
b. Use the index number to enable or disable the module:
n To enable the module:
(config)> service location source 0 enable true
(config)>
n To disable the module:
(config)> service location source 0 enable false
(config)>
4. Alternatively, you can use the index number to delete the USB location source:
(config)> del service location 0
(config)>
5. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
6. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Configure the device to use a user-defined static location
You can configured your Connect IT 16/48 device to use a user-defined static location.
WebUI

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English