Digi Connect IT 16 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 16/48 User Guide
50
Wide Area Networks (WANs)
The Connect IT 16/48 device is preconfigured with one Wide Area Network (WAN), named ETH1, and
one Wireless Wide Area Network (WWAN), named WWAN.
You can modify configuration settings for the existing WAN and WWANs, and you can create new WANs
and WWANs.
This section contains the following topics:
Wide Area Networks (WANs) and Wireless Wide Area Networks (WWANs) 51
Configure WAN/WWAN priority and default route metrics 51
WAN/WWAN failover 54
Configure SureLink active recovery to detect WAN/WWAN failures 55
Configure the device to reboot when a failure is detected 62
Disable SureLink 68
Example: Use a ping test for WAN failover from Ethernet to cellular 72
Using Ethernet devices in a WAN 74
Using cellular modems in a Wireless WAN (WWAN) 74
Configure a Wide Area Network (WAN) 96
Configure a Wireless Wide Area Network (WWAN) 103
Show WAN and WWAN status and statistics 112
Delete a WAN or WWAN 114

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English