Digi Connect IT 16 User Manual

Configuration and management Review Connect IT 16/48 default settings
Digi Connect IT® 16/48 User Guide
29
Review Connect IT 16/48 default settings
You can review the default settings for your Connect IT 16/48 device by using the local WebUI or Digi
Remote Manager:
Local WebUI
1. Log into the Connect IT 16/48 WebUI as a user with Admin access. See Using the web interface
for details.
2. On the menu, click System > Device Configuration.
Digi Remote Manager
1. If you have not already done so, connect to your Digi Remote Manager account.
2. Click Device Management to display a list of your devices.
3. Locate and select your device as described in Use Digi Remote Manager to view and manage
your device.
4. Click Configure.
The following tables list important factory default settings for the Connect IT 16/48.
Default interface configuration
Interface type
Preconfigured
interfaces Devices Default configuration
Wide Area Networks (WAN)
n ETH1 n Ethernet:
ETH1
n Firewall zone: Internal
n WAN priority: Metric= 1
n l IP Address: DHCP
client
n Digi SureLink
TM
enabled for IPv4
n ETH2 n Ethernet:
ETH2
n Firewall zone: Internal
n WAN priority: Metric= 5
n l IP Address: DHCP
client
n Digi SureLink
TM
enabled for IPv4
n SFP1 n Ethernet:
SFP1
n Firewall zone: Internal
n WAN priority: Metric= 1
n l IP Address: DHCP
client
n Digi SureLink
TM
enabled for IPv4

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English