User authentication Local users
Digi Connect IT® 16/48 User Guide
515
(config auth user new_user 2fa)> window_size 3
(config auth user new_user 2fa)>
h. Configure the login limit. This represents the number of times that the user is allowed to
attempt to log in during the Login limit period. Set to 0 to allow an unlimited number of
login attempts during the Login limit period
(config auth user new_user 2fa)> login_limit 3
(config auth user new_user 2fa)>
i. Configure the login limit period. This is the amount of time that the user is allowed to
attempt to log in.
(config auth user new_user 2fa)> login_limit_period value
(config auth user new_user 2fa)>
where value is any number of weeks, days, hours, minutes, or seconds, and takes the
format number{w|d|h|m|s}.
For example, to set login_limit_period to ten minutes, enter either 10m or 600s:
(config auth user name 2fa)> login_limit_period 600s
(config auth user name 2fa)>
The default is 30s.
j. Scratch codes are emergency codes that may be used once, at any time. To add a scratch
code:
i. Change to the user's scratch code node:
(config auth user new_user 2fa)> scratch_code
(config auth user new_user 2fa scratch_code)>
ii. Add a scratch code:
(config auth user new_user 2fa scratch_code)> add end code
(config auth user new_user 2fa scratch_code)>
Where code is an digit number, with a minimum of 10000000.
iii. To add additional scratch codes, use the add end code command again.
9. Save the configuration and apply the change:
(config auth user new 2fa scratch_code)> save
Configuration saved.
>
10. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
Delete a local user
To delete a user from your Connect IT 16/48:
WebUI
To Next Page
Loading...
Need help?
General