Digi Connect IT 16 User Manual

Interfaces Bridging
Digi Connect IT® 16/48 User Guide
155
1 /network/wireless/ap/digi_ap
(config)>
ii. Use the index number to delete the appropriate device. For example, to delete the
Digi AP (Wi-Fi1) Wi-Fi access point from the bridge:
(config)> del network bridge lan device
(config)>
Note If you are deleting multiple devices from the bridge, the device index may be
reordered after each deletion. As a result, best practice is to perform a show network
bridge lan1 device command after each device is deleted to determine the new
index numbering.
b. Add devices to the bridge:
i. Determine available devices:
(config network bridge my_bridge)> .. .. interface lan device ?
Default value: /network/bridge/lan
Current value: /network/bridge/lan
(config network bridge my_bridge)>
ii. Add the appropriate device. For example, to add the Digi AP (Wi-Fi1) Wi-Fi access
point:
(config network bridge my_bridge)> add device end
/network/wireless/ap/digi_ap
(config)>
5. (Optional) Enable Spanning Tree Protocol (STP).
STP is used when multiple LANs are configured on the same device, to prevent bridge loops and
other routing conflicts.
a. Enable STP:
(config)> network bridge eth2 stp enable true
b. Set the number of seconds that the device will spend in each of the listening and learning
states before the bridge begins forwarding data:
(config)> network bridge eth2 stp forward_delay num
(config)>
The default is 2 seconds.
6. Save the configuration and apply the change:
(config)> save
Configuration saved.
>

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English