Digi Connect IT 16

Serial port Add a USB console port
Digi Connect IT® 16/48 User Guide
175
(config serial USB_port)> add service tcp acl interface end
value
(config serial USB_port)>
Where value is an interface defined on your device.
Display a list of available interfaces:
Use ... network interface ? to display interface information:
(config serial USB_port)> ... network interface ?
Interfaces
Additional Configuration
-------------------------------------------
defaultip Default IP
defaultlinklocal Default Link-local IP
eth1 ETH1
eth2 ETH2
loopback Loopback
sfp1 SFP1
sfp2 SFP2
wwan WWAN
(config serial USB_port)>
Repeat this step to list additional interfaces.
n To limit access based on firewall zones:
(config serial USB_port)> add service tcp acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config serial USB_port)> ... firewall zone ?
Zones: A list of groups of network interfaces that
can be referred to by packet
filtering rules and access control lists.
Additional Configuration
--------------------------------------------------
-----------------------------
any
dynamic_routes
edge
external
internal
ipsec