Digi Connect IT 16

Routing Virtual Router Redundancy Protocol (VRRP)
Digi Connect IT® 16/48 User Guide
223
5. Click Enable.
6. For Interface, select Interface: ETH2.
7. For Router ID, leave at the default setting of 50.
8. For Priority, leave at the default setting of 100.
9. Click to expand Virtual IP addresses.
10. Click  to add a virtual IP address.
11. For Virtual IP, type 192.168.3.3.
Task 2: Configure VRRP+ on device one
1. Click to expand VRRP+.
2. Click Enable.
3. Click to expand Monitor interfaces.
4. Click  to add an interface for monitoring.
5. Select Interface: WWAN.
6. For Priority modifier, type 30.
Task 3: Configure the IP address for the VRRP interface, ETH2, on device one
1. Click Network > Interfaces > ETH2 > IPv4
2. For Address, type 192.168.3.1/24.