Digi Connect IT 16 - Page 3

Revision Date Description
G September 2020
Release of Digi Connect IT 16/48 firmware
version 20.8:
n Support for NEMO/DMNR virtual private
networks.
n Support for serial Modbus Gateway.
n Support for Ethernet network bonding.
n Support for VRRP+, an extension to the
VRRP standard that uses network
probing to monitor connections through
VRRP-enabled devices.
n Cloud service enhancements:
l Reduced data usage for reporting
health metrics to Digi Remote
Manager.
Added Monitoring > Device Health >
Only report changed values to Digi
Remote Manager option to control
sending metrics to Digi Remote
Manager on the basis of whether the
values have changed since they were
last reported.
l Added Monitoring > Device Health >
Data point tuning configuration
options to fine tune what datapoints
are uploaded as health metrics to
Digi Remote Manager.
l Added the ability to select Digi aView
as the cloud service.
n Added the ability to duplicate firmware
to copy the active firmware to the
secondary firmware partition.
n Moved the update firmware CLI
command to system firmware update.
n Added new Authoritative option under
TACACS+, RADIUS, and LDAP user
authentication methods to prevent
falling back to additional authentication
methods.
n Cisco Umbrella content filtering.
n Added options under System > Log >
Server list to allow users to specify the
TCP/UDP protocol and port of the
remote syslog server.
Digi Connect IT® 16/48 User Guide
3