Digi Connect IT 16 User Manual

Services Configure the web administration service
Digi Connect IT® 16/48 User Guide
336
protocols. This option is disabled by default, which means that only TLS 1.2 and later encryption
protocols are allowed with HTTPS connections.
9. View is set to Auto by default and normally should not be changed.
10. Legacy port redirection is used to redirect client HTTP requests to the HTTPS service. Legacy
port redirection is enabled by default, and normally these settings should not be changed. To
disable legacy port redirection, click to expand Legacy port redirection and deselect Enable.
11. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Configure access control:
n To limit access to specified IPv4 addresses and networks:
(config)> add service web_admin acl address end value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 192.168.1.0/24.
l any: No limit to IPv4 addresses that can access the web administratrion service.
Repeat this step to list additional IP addresses or networks.
n To limit access to specified IPv6 addresses and networks:
(config)> add service web_admin acl address6 end value
(config)>
Where value can be:
l A single IP address or host name.
l A network designation in CIDR notation, for example, 2001:db8::/48.
l any: No limit to IPv6 addresses that can access the web administratrion service.
Repeat this step to list additional IP addresses or networks.
n To limit access to hosts connected through a specified interface on the Connect IT
16/48 device:

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English