Digi Connect IT 16

Services Configure SSHaccess
Digi Connect IT® 16/48 User Guide
345
eth1 ETH1
eth2 ETH2
loopback Loopback
sfp1 SFP1
sfp2 SFP2
wwan WWAN
(config)>
Repeat this step to list additional interfaces.
n To limit access based on firewall zones:
(config)> add service ssh acl zone end value
Where value is a firewall zone defined on your device, or the any keyword.
Display a list of available firewall zones:
Type ... firewall zone ? at the config prompt:
(config)> ... firewall zone ?
Zones: A list of groups of network interfaces that can be
referred to by packet
filtering rules and access control lists.
Additional Configuration
---------------------------------------------------------
----------------------
any
dynamic_routes
edge
external
internal
ipsec
loopback
setup
(config)>
Repeat this step to list additional firewall zones.
4. (Optional) Set the private key in PEM format. If not set, the device will use an automatically-
generated key.
(config)> service ssh key key.pem
(config)>
5. (Optional) Configure Multicast DNS (mDNS)
mDNS is a protocol that resolves host names in small networks that do not have a DNS server.
mDNS is enabled by default. To disable mDNS, or enable it if it has been disabled: