Digi Connect IT 16

Applications Digidevice module
Digi Connect IT® 16/48 User Guide
461
iv. Click  to add a custom script.
v. For Label, type Show system application.
vi. For Run mode, select On boot.
vii. For Exit action, select Restart script.
viii. For Commands, type python /etc/config/scripts/showsystem.py.
ix. Click Apply to save the configuration and apply the change.
Command line
i. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access
selection menu. Type admin to access the Admin CLI.
ii. At the command line, type config to enter configuration mode:
> config
(config)>
iii. Add an application entry:
(config)> add system schedule script end
(config system schedule script 0)>