Digi Connect IT 16 User Manual

User authentication Terminal Access Controller Access-Control System Plus (TACACS+)
Digi Connect IT® 16/48 User Guide
523
5. (Optional) Configure the type of service. This is the value of the service attribute in the the
TACACS+ server's configuration. For example, in TACACS+ user configuration, the value of the
service attribute in the sample tac_plus.conf file is system, which is also the default setting in
the Connect IT 16/48 configuration.
(config)> auth tacacs+ service service-name
(config)>
6. Add a TACACS+ server:
a. Add the server:
(config)> add auth tacacs+ server end
(config auth tacacs+ server 0)>
b. Enter the TACACS+ server's IP address or hostname:
(config auth tacacs+ server 0)> hostname hostname|ip-address
(config auth tacacs+ server 0)>
c. (Optional) Change the default port setting to the appropriate port:
(config auth tacacs+ server 0)> port port
(config auth tacacs+ server 0)>
d. (Optional) Repeat the above steps to add additional TACACS+ servers.
7. Add TACACS+ to the authentication methods. Authentication methods are attempted in the
order they are listed until the first successful authentication result is returned. This example
will add TACACS+ to the end of the list. See User authentication methods for information about
adding methods to the beginning or middle of the list.
(config)> add auth method end tacacs+
(config)>
8. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
9. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English