Digi Connect IT 16 User Manual

User authentication Example user configuration
Digi Connect IT® 16/48 User Guide
550
1 radius
(config)>
4. Create the first authentication group:
(config)> add auth group serialgroup1
(config auth group serialgroup1)>
5. Enable serial access for serialgroup1:
(config auth group serialgroup1)> acl serial enable true
(config auth group serialgroup1)>
6. Limit the user's access to serial port 1:
(config auth group serialgroup1)> add acl serial ports end port1
(config auth group serialgroup1)>
7. Move down one step in the configuration by typing two periods (..):
(config auth group serialgroup1)> ..
(config auth group)>
8. Create the second authentication group:
(config auth group)> add serialgroup2
(config auth group serialgroup2)>
9. Enable serial access for serialgroup2:
(config auth group serialgroup2)> acl serial enable true
(config auth group serialgroup2)>
10. Limit the user's access to serial ports 2, 4, and 8:
(config auth group serialgroup2)> add acl serial ports end port2
(config auth group serialgroup2)> add acl serial ports end port4
(config auth group serialgroup2)> add acl serial ports end port8
11. Save the configuration and apply the change:
(config auth user serialuser2)> save
Configuration saved.
>
12. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu. Type quit to disconnect from the device.
13. Configure the users on the RADIUSserver:
a. On the ubuntu machine hosting the FreeRadius server, open the
/etc/freeradius/3.0/users file:

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English