Central management Configure Digi Remote Manager
Digi Connect IT® 16/48 User Guide
639
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Digi Remote Manager support is enabled by default. To disable Digi Remote Manager support:
(config)> cloud enable false
(config)>
4. (Optional) Set the service:
(config)> cloud service value
(config)>
where value is either:
n drm: Digi Remote Manager
n aview: Digi aView
The default is Digi Remote Manager.
5. (Optional) Set the URL for the central management server. The default is the Digi Remote
Manager server, my.devicecloud.com.
(config)> cloud drm drm_url url
(config)>
6. (Optional) Set the amount of time that the Connect IT 16/48 device should wait before
reattempting to connect to the remotecloud services after being disconnected. The minimum
value is ten seconds. The default is 30 seconds.
(config)> cloud drm retry_interval value
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set the retry interval to ten minutes, enter either 10m or 600s:
(config)> cloud drm retry_interval 600s
(config)>
7. (Optional) Set the amount of time that the Connect IT 16/48 device should wait between
sending keep-alive messages to the Digi Remote Manager when using a non-cellular interface.
Allowed values are from 30 seconds to two hours. The default is 60 seconds.
(config)> cloud drm keep_alive value
(config)>
where value is any number of hours, minutes, or seconds, and takes the format number{h|m|s}.
For example, to set the keep-alive interval to ten minutes, enter either 10m or 600s:
(config)> cloud drm keep_alive 600s
(config)>
8. (Optional) Set the amount of time that the Connect IT 16/48 device should wait between
sending keep-alive messages to the Digi Remote Manager when using a cellular interface.
To Next Page
Loading...
Need help?
General