Digi Connect IT 16 User Manual

Interfaces Wide Area Networks (WANs)
Digi Connect IT® 16/48 User Guide
99
when the interface is the primary route.
n Never: Never use DNS servers for this interface.
k. Enable DHCP Hostname to instruct the Connect IT 16/48 device to include the device's
system name with DHCP requests as the Client FQDN option. The DHCP server can then
be configured to register the device's hostname and IP address with an associated DNS
server.
n See RFC4702 for further information about DHCP server support for the Client
FQDNoption.
n See Configure system information for information about setting the Connect IT
16/48 device's system name.
10. (Optional) Click to expand MACaddress blacklist.
Incoming packets will be dropped from any devices whose MAC addresses is included in the
MAC address blacklist.
a. Click to expand MACaddress blacklist.
b. For Add MACaddress, click .
c. Type the MAC address.
11. (Optional) Click to expand MACaddress whitelist.
If there whitelist entries are specified, incoming packets will only be accepted from the listed
MAC addresses.
a. Click to expand MACaddress whitelist.
b. For Add MACaddress, click .
c. Type the MAC address.
12. Click Apply to save the configuration and apply the change.
Command line
1. Log into the Connect IT 16/48 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu. Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>
3. Create a new WAN or edit an existing one:
n To create a new WAN named my_wan:
(config)> add network interface my_wan
(config network interface my_wan)>

Digi Connect IT 16 Specifications

General

Brand	Digi
Model	Connect IT 16
Category	Server
Language	English