Digital Dream DDCS-Expert - Type in the Tool Number and Enter; Fixed Probe Finished

Digital Dream Standalone Motion Controller DDCS-Expert Users ManualPage-52
The X / Y/ Z / 4th / 5th start to move to the inital positon in Mach coordinate. after arrive to
that position, it start to probe down. It will probe the times as we set, and calculate an average
value, and the cutter retract a distance. Then the fixed probe finished.
The probe squence of each a axis is Z axis -- X axis -- Y axis -- 4th axis -- 5th axis.
Figure 5-54 Type In the tool number and Enter
Figure 5-55 Fixed Probe Finished