Dinstar MTG2000 - Page 116

MTG2000 Trunk Gateway User Manual V| Dinstar
110
CDR to SYSLOG server.
FILELOG
Configuration
FILELOG
Enable
To save the log of the device, which can be
downloaded in the data download.
Log Type
The type of file log, users can select signal
syslog, system syslog, management syslog and
media syslog.
FILELOG Level
Configure FILELOG Level, users can set five
levels such as NONE, DEBUG, INFO, NOTICE,
WARNING.
Save CDR
When enabled, the device will automatically send
CDR to FILELOG server.
NATS Server
Config
Enable NATS
To send bills to NATS server.
Server IP
Configure NATS server domain name or IP
address.
Server Port
Configure the connection port of NATS server.
User Name
Configure the authentication username of NATS
server.
Password
Configure the authentication password of NATS
server.
TLS Enable
Enable TLS encrypted transmission.
Send CDR To
NATS Server
When enabled, the device will automatically send
CDR to NATS server.
E1 Auto Close
Config
Enable Auto
Close
E1 port will be automatically closed when the
detection conditions are met.
Judgment By
Configure the basis for E1 Auto Close, such as
Eth State, Sip Server State, Register State and
Continuous Call Timeout.
Qos
Qos Type
Do not enable /DS, whether to enable Qos
service, not enabled by default.
NTP
Configuration
NTP Enable
Whether to enable NTP to synchronize the
system time, it is enabled by default.
Primary NTP
Server Address
Primary NTP server address.
Primary NTP
Server Port
The default port of the primary NTP server is
123.
Secondary NTP
Server Address
The address of the secondary NTP server.
Secondary NTP
Server Port
The default port of the secondary NTP server is
123.