ENGINE ELECTRICAL
-
Ignition System
8-255
SERVICE POINTS OF INSTALLATION
4. INSTALLATION OF DISTRIBUTOR
(1)
Turn the crankshaft so that the No. 1 cylinder is at
compression top dead center.
Caution
Be careful not to turn it to the No. 4 cylinder
compression top dead center by mistake.
(2) Align the distributor housing and gear mating marks.
Front of engine
(Timing belt side)
Housing’s
mating mark
7EL0026
(3) Install the distributor to the engine while aligning the
distributor’s installation flange with the center of the
distributor installation stud.
2. INSTALLATION OF SPARK PLUG CABLE
Improper arrangement of spark plug cables will induce
voltage between the cables, causing miss firing and
developing a surge at acceleration in high-speed operation.
Therefore, be careful to arrange the spark plug cables
properly by the following procedure.
1. Install the spark plug cable clamps as shown in the
illustration.
2. The numerals on the support and clamp indicate the
spark plug cable No.
3. Pay attention to the following items when the spark
plug cables are installed.
(1)
Install the cables securely to avoid possible contact
with metal parts.
(2) Install the cables neatly, ensuring they are not too
tight, loose, twisted or kinked.
Spark plug
cable No. 1
Spark plug
cable No. 3
Spark plug
cable No. 5
Front bank
View
A
Spark plug
cable No. 2
Spark plug
cable No. 4
spark plug
cable No. 6
7EL0109
To Next Page
Loading...
