13.5.3 Adjusting the flap clamp lifting device
40+3 mm
Standard checking
The flap clamp lifting device lifts the flap c lamps 5 before swivelling out
so that they can pass over the closed flap clamps 6 of the feeding
clamps without hindrance. The lifting height above the fabric sliding
sheet must amount to
14 + 3 mm
.
Correction of the stop (flap clamp lowered):
Loosen nut 2.
Turn screw 1 until there is a distance of 3 +/- 1 mm between lever
and stop.
Ti ghten nut 2.
Check the flap clamp height above the fabric sliding sheet
(Dimension
14+3 mm
).
Correction of the stop (flap clamp raised):
Select the test program
Checking the loading operation w ith
feeding clamp
. See also Programming Instructions,
chapter 7.4.5.
Step on the left pedal until the flap c lamps are swivelled in and
raised.
Loosen the nut.
Turn the screw until the flap clamps are raised high enough to pass
over the flap clamps of the feeding clamp without hindrance
(Dimension
14 + 3 mm
).
Step on the left pedal once again and let the flap clamps swivel out.
Check the free movement of same.
Ti ghten the nut.
116
43 2165
1
4
+
3
m
m
To Next Page
Loading...
