13.5.4 Adjusting the flap clamps as to the rest table
40 + 3 mm
Standard checking
Not only the swivelling width of the flap clamps but also the position of
the rest table can be adjusted. The swivelling width can individually be
set according to the operator; then the rest table has to be adjusted so
that the stationary flap clamp is flush and parallel to the rest table with
adistanceof
8to12mm
(see sketch page 112).
Correction of the sw ivelling width
Loosen nut 3.
Set the swivelling width by turning the bush 4.
Ti ghten nut 3.
Correction of the rest table
Loosen screw 5.
Turn rod 6 until the rest table is flush with the stationary flap clamp.
Tighten screw 5.
Loosen screws 7.
Adjust the rest table parallel to the flap clamp with a distance of
8-12 mm.
Tighten screws 7 again.
3
117
43
56 7
To Next Page
Loading...
