Mtter
Bush
10
±3 mm
Adjusting the flap transfer position
Precondition:
The flap clamp lifting device is adjusted as described in chapter 13.5.3.
Standard checking
The stationary flap c lamp 1 of the flap turning device must stand
20
±
3mm
underneath the rest table 3. The lateral distance of flap
clamp 1 of the flap turning device and of flap clamp 2 of the feeding
device should amount to
10
±
3mm
.
The
stationary
flap clamps of the turning and feeding device have to
be flush.
Correction of the distance to the rest table
Loosen the counternut 5.
Turn the screw 4 so that the stationary flap clamp 1 stands
20 ± 3 mm
underneath the table 2.
Ti ghten the counternut 5.
Correction of the lateral distance of the flap clamps
Loosen the counternut 7 and set the distance with the adjusting
screw 6.
Ti ghten the counternut 7.
Correction of transfer (flap clamps flush)
Loosen nut 11.
Turnthebush12untiltheflaptransferfromflapclampFtoflap
clamp B is carried out without delay. (i.e. adjust flap clamps 1 and 2
so that they are flush)
Ti ghten nut 11.
54910
32 1
2
0
±
3
m
m
10 ± 3 mm
11
12
122
67
To Next Page
Loading...
