3
13.8 Sewing test according to pattern
The settings according to these service instructions are followed by the
adjustment as per pattern with a correspondingly prepared workpiece
(light-coloured fabric).
Draw vertical and horizontal lines on flap 2 and on the workpiece.
Position the piping strip on the rest table.
Position the flap 2 at the laser marking 1 aligned in parallel
position. Adjust the laser marking in such a way that the
flap projects from the pocket opening line to the right by the
spacing PL1.
(see opposite sketch for determination of same)
Align the workpiece.
The horizontal and vertical lines of the workpiece and the flap must
be congruent.
Carry out the sewing operation.
Take the workpiece off and turn.
Check the workpiece and correct faulty sewing results.
(see chapter 13.8)
Pocket opening line
e.g.: PL1 = 60 - 5 = 55
Pz = F lap cut
PT = Flap depth
125
32 L1
2
To Next Page
Loading...
