Safety
Operating Instructions 867-M PREMIUM - 00.0 - 02/201512
Obligations
of the operator
Observe the country-specific safety and accident prevention reg-
ulations and the legal regulations concerning industrial safety and
the protection of the environment.
All warnings and safety signs on the machine must always be in
legible condition and may not be removed. Missing or damaged
labels should be replaced immediately.
Requirements to
be met by the
personnel
The machine may only be set up by qualified technicians.
Maintenance work and repairs may only be carried out by qualified
technicians.
Work on electrical equipment may only be carried out by qualified
specialists.
Only authorized persons may work on the machine. Every person
who works on the machine must first have understood these
instructions.
Operation Inspect the machine while in use for any externally visible damage.
Stop working if you notice any changes to the machine. Report
any changes to your supervisor. A damaged machine must no
longer be used.
Safety
equipment
Safety equipment should not be removed or deactivated. If this
cannot be avoided for a repair operation, the safety equipment
must be refitted and put back into service immediately afterwards.
To Next Page
Loading...
Need help?
General
