Customizing MimioStudio
n Create a combined surface using two or more MimioTeach devices and two or more
MimioCapture devices
You can combine up to four different surfaces.
These settings are only used when your MimioTeach or Mimio Interactive device is used to
capture digital ink.
To adjust the settings for a MimioTeach or Mimio Interactive device
1. Choose the device to adjust from the Device list.
2. Make the changes you want to the settings.
3. Click Apply.
To adjust surface size for a MimioTeach or Mimio Interactive device
Do one of the following:
l Choose a size from the Surface Size list.
l Choose Custom from the Surface Size list and enter the desired values into the
Width and Height boxes.
l Click Auto Size and touch a MimioCapture or Mimio Capture Kit pen at the
location shown in the Auto Size dialog box.
To adjust the mounting location for a Mimio Interactive bar
Choose a mounting location from the Device Mounting list.
The sensors on the Mimio Interactive bar must point in toward the writing surface.
134
To Next Page
Loading...