Dynamic RHINO2 DS90 User Manual

beep when the scooter moves forward, and the forward speed will be limited by the Maximum Reverse Speed
parameter. For this reason, do not use Motor Reverse for left-handed operation. Use Swap Throttle Direction
instead.
6.5.1.4 Enable Beeper
Parameter Possible Values Default HHP Lite Std Adv
Enable Beeper No / Yes Yes
✓ ✓ ✓ ✓
Yes — The beeper will beep according to the settings of Flash Code Beeper, Sleep Beeper,
Motion Beeper and Deep Discharge Beeper.
No — All beeper functions are disabled.
6.5.1.5 Flash Code Beeper
Parameter Possible Values Default HHP Lite Std Adv
Flash Code Beeper No / Yes No
✓ ✓ ✓ ✓
This parameter is only used when Enable Beeper has the value 'Yes'.
Yes — If a flash code is shown on the Status LED, the buzzer beeps the same number of
beeps as the flash code number.
No — The buzzer does not beep during a fault.
6.5.1.6 Sleep Beeper
Parameter Possible Values Default HHP Lite Std Adv
Sleep Beeper No / Yes Yes
✓ ✓ ✓ ✓
This parameter is only used when Enable Beeper has the value 'Yes'.
Yes — When the controller goes to sleep, the buzzer beeps for one second.
No — When the controller goes to sleep, the buzzer does not beep.
6.5.1.7 Motion Beeper
Parameter Possible Values Default HHP Lite Std Adv
Motion Beeper
Wizard
None
Reverse
Forward/Reverse
HHP
Yes
No
Wizard
Reverse
HHP
No
✓
✓ ✓ ✓
This parameter is only used when Enable Beeper has the value 'Yes'.
None — The scooter does not beep when it is moving
Reverse — The scooter beeps only when it is moving in the reverse direction
Forward/Reverse — The scooter beeps when it is moving in any direction
GBK51948 RHINO2
Installation Manual Issue 5
Programming - Page 73

Dynamic RHINO2 DS90 Specifications

General

Brand	Dynamic
Model	RHINO2 DS90
Category	Controller
Language	English