Version 5 Model 200i and 250i Motorcycle Dynamometer Installation Guide
Index-iii
P
PDA, see power distribution assembly
pendant, routing cables 2-25
pickup card 2-11
wiring to breakout board 2-31
power
50 Hz B-7
60 Hz B-2
connecting the dyno, 50 Hz B-11
connecting the dyno, 60 Hz B-6
hard wiring 60 Hz B-5
hard wiring, 50 Hz B-10
installation 50 Hz B-7
installation 60 Hz B-2
installing receptacle 60 Hz B-3
installing receptacle, 50 Hz B-8
main dyno 3-2
replacing power plug 50 Hz B-10
replacing power plug 60 Hz B-5
requirements 50 Hz B-7
routing cable 2-8
testing voltages 50 Hz B-9
testing voltages 60 Hz B-4
verifying operation, 50 Hz B-11
verifying operation, 60 Hz B-6
power cable, routing 2-8
power carriage 3-42
flange bearing 3-43
hand crank 3-43
parts list 3-42
testing 3-49
power distribution assembly 4-9
power line frequency C-3
power line voltage C-3
pre-run inspection 5-9
preventative maintenance 5-12
primary inductive pickup 5-5
pump assembly 3-23
pump head maintenance 3-26
R
ramp bracket 2-40
red head anchor
contact information A-1
installation A-2
setting tool A-3
warnings A-1
removing
center panel 3-6
drum covers 3-3
tire carriage 3-5
requirements
battery 1-5
chassis 1-5
computer specifications 1-7
electrical 1-7
environmental 1-8
forklift 1-8
ground hook 1-8
phone, internet access 1-8
power 50 Hz B-7
power 60 Hz B-2
shop air 1-7
tie down straps 1-8
routing cables 2-26
power 2-8
RPM pickup
connecting
primary inductive pickup 5-5
secondary inductive pickup 5-7
S
safety switch D-6
screw support bracket E-4
extended carriage E-10
secondary inductive pickup 5-7
sensor, air pump 3-25
setting tool A-3
specifications
length, height, width, weight 1-5
starter brace 2-15
status indicator 4-4
support arm 2-21
remove from crate 2-2
To Next Page
Loading...
