Eaton easy800 User Manual

8 800 Settings
8.2 System
302 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
8.2 System
8.2.1 Switch on input delay
The easy800 device is factory set to evaluate input signals with an input
delay, the so-called DEBOUNCE function. This ensures that any contact
bouncing of switches and pushbuttons is masked out.
However, for many applications, it is necessary to evaluate very short input
signals. In this case, the debounce function can be switched off.
The input delay is set in the System menu.
▶ Press DEL and ALT to call up the System menu.
▶ Move to the menu SYSTEM and then to the DEBOUNCE menu.
Activating DEBOUNCE
▶ To activate DEBOUNCE, choose DEBOUNCE and press OK.
The debounce is activated and the display changes to DEBOUNCE å.
▶ Press ESC to return to the previous menu.
Deactivating DEBOUNCE
If the menu displays DEBOUNCE
å (with a tick), this means that the
debounce function is already activated.
▶ To deactivate DEBOUNCE, choose DEBOUNCE å and press OK.
Debounce mode will be deactivated and the display will show DEBOUNCE
without a tick.
￫
If the easy800 device is protected with an STD PASSWORD,
you must remove password protection before you can call the
system menu.
DEBOUNCE åÆ
P PUSHBUTTONS
RUN MODE
CARD MODE æ
￫
How easy800 input signals are processed internally,
￫ Section “Input delay (debounce)“, Page 321.

Eaton easy800 Specifications

General

Brand	Eaton
Model	easy800
Category	Relays
Language	English