Eaton easy800

2 Installation
2.6 Connecting outputs
50 Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com
Connecting transistor outputs of the expansion unit
Figure 51:Digital transistor outputs EASY6..-DC-TE and EASY4...-DC-TE
a EASY4... -DC-TE
b EASY6... -DC-TE
2.6.3 Connect analog output
All easy800 standard devices with a 24 V DC supply voltage have an analog
output QA 01. QA 01 can be used to output a DC voltage from 0 - 10 V, with
a 10-bit resolution, value range 0 - 1023.
On the easy800 standard from device version 02, it is also possible to
connect the EASY406-DC-ME and EASY411-DC-ME DC expansion units with
an analog output (￫ Section “Connecting DC inputs of the EASY4..-DC-ME
expansion units“, Page 39).
The analog output can be used, for example, for controlling solenoid valves
and other actuators.
Observe the hazard warnings concerning the processing of analog signals
(￫ section 2.5.2, “Connecting analog inputs”, page 40) and the note
concerning the same reference potential (chassis ground).
F 10 A
f 2.5 A
0 V H
0 V
Q
24 V
Q
aa
b
(20.4 – 28.8 V H)
+ 24 V H
RL
5 W/24 V
0.5 A
24 V H
0.5 A