2 Installation
2.6 Connecting outputs
Control Relay easy800 11/11 MN04902001Z-EN www.eaton.com 51
Connect the analog output of 800 standard
Connecting solenoid valve
Figure 52:Connecting a solenoid valve; the 0V terminals are connected inside the device.
Setpoint entry for a drive
Figure 53:Setpoint entry for a drive; the 0V terminals are connected inside the device.
Connecting the analog output of the EASY4..-DC-ME expansion units
Analog expansion units are used to increase the number of outputs.
The EASY406-DC-ME analog expansion
unit
offers
you
one
and
the
EASY411-DC-ME two additional analog outputs. Both devices provide a
DC voltage of 0 - 10 V with a 10-bit resolution and 0 - 1023 value range.
Connect the actuator(s) to QA1(/QA2) and to the relevant 0 V terminal to its
(their) left.
To Next Page
Loading...
